Skip links

Cabots Aquadeck Natural Exterior Decking Oil – 10L

Cabots Aquadeck Natural Exterior Decking Oil – 10L

Our Aquadeck lasts twice as long as other oil based decking oils, providing your exterior timber with protection while simultaneously enhancing its natural look. You can use Aquadeck over any existing coating*, no sanding required#

*Existing coating must be at least 30 days old. If the existing coating has peeled, flaked or deteriorated unevenly, the coating must be completely removed using a coatings stripper or sanding back to bare timber.

#Important: The final look will be impacted by the condition and colour of the existing coating. If the existing coating has deteriorated unevenly or is a darker colour than the Cabot’s Aquadeck colour chosen, it is recommended to remove all existing coating first, then clean with Cabot’s Deck Clean.

Category:

Description

Aquadeck’s advanced dual technology allows natural oils to penetrate and nourish timber, provides a semi-transparent finish and creates a durable acrylic barrier for a beautiful natural finish.

  • Lasts twice as long as traditional decking oils
  • Highly durable
  • Low odour decking oil

 

Get Ready For Outdoor Entertaining

Our Aquadeck lasts twice as long other oil based decking oils, providing your exterior timber with protection while simultaneously enhancing its natural look
PreparationNew Bare Timber

To coat new bare timber immediately, scrub damp timber with Cabot’s New Timber Prep, following label instructions. New Timber Prep will draw out tannins and oils quickly from the surface, allowing you to skip the 4-6 weeks weathering process required for new timber. Always follow New Timber Prep with Cabot’s Deck Clean following label instructions. Remove excess water from the surface with squeegee on Cabot’s Deck Prep brush, and allow timber to dry for at least 1 hour. Note: Cooler conditions could slow down the drying time of the timber.

Previously Painted or Varnished Timber

Remove back to bare timber using a paint stripper, or sanding. For exterior surfaces clean with Cabot’s Deck Clean following label instructions.

Previously Stained and Oiled Timber

For exterior surfaces clean with Cabot’s Deck Clean following label instructions. Test if the surface is ready for coating by sprinkling water on the timber. If the water ‘beads’ on the surface further weathering, sanding or use of a timber stripper is required before applying Cabot’s Aquadeck. If the water soaks into the surface, you are ready to apply Cabot’s Aquadeck. See application steps below.

Weathered and Grey Timber

Sand timber back to fresh timber. Clean with Cabot’s Deck Clean following label instructions. Note: Fill holes and imperfections with a suitable timber putty after applying the first coat of Aquadeck.

 

Range: Base colours below are available instore to purchase. From these colour bases, you can tint to 100’s of colours. To view our range, view the colour visualiser.

Available sizes: 10 LITRE

 

This website uses cookies to improve your web experience.